HomeHome & Garden

How To Replace And Install A Light Switch – The Guide For Men Only!

How To Replace And Install A Light Switch – The Guide For Men Only!
Like Tweet Pin it Share Share Email

There are many times when a homeowner wishes to change the location of a light switch or install a brand new switch in a renovated room. Unfortunately, the process can be complicated for beginners and requires dealing with electrical wiring.

It’s usually best to consult a residential electrician before cutting into the drywall and handling wiring, even if the power has been disconnected properly.

Moving a Light Switch

Sometimes moving a light switch to an entirely different area is necessary. Some homes, for example, have poor wiring design and place all outlets on one side of the room.

Moving a switch, however, can be a fairly complicated process and requires first turning off the power to the area. Next, a gap must be cut in the drywall, and new 14 gage wiring must be hurry to the new area.

Passing divider studs requires cutting a one-inch opening into the drywall at each stud which must be patched later.

It can take many hours for an amateur to move a light switch, but an electrician likeĀ electrical contractor Las Vegas can complete the task quickly.

Light Switch Installation

Installing a new light switch can be even more complicated than moving an existing wall switch. There are three main types of switches to choose from: toggle, mercury, and silent.

Complete installation of a new wall switch requires cutting into the drywall and feeding wire through the wall to the new source.

Electrical wiring must be stripped and properly installed on the new switch to control a single light.

Comments (0)

Leave a Reply

Your email address will not be published. Required fields are marked *